Hello,
I have aquired a Next Cube with a Dimension board and I'm trying to
resurect it from it's grave.
It appears the Hard drive is dead since it says "Waiting for
Drive....." when I execute the "bsd" command from the monitor.
So I figure I need a new SCSI drive and some software.
So my questions are?
1. What OS should I use to run both the next "040" board and make use
of the Dimension board?
2. Where would one locate this software?
3. If I were to get a new SCSI drive what should I look for? I seem to
read that 2 Gig was the limit and I figure I need a 5.25 form factor
due to the mounting size of the Cube.
4. The optical drive had a CD in it (Lotus Improve Beta 1) which
appears to be a non standard size. Is there a special Disk Caddy for
this drive since I see the OS comes on CD? Again where would one locate
one?
Thanks for any help out there.
